Amano Time Guardian Series Guide de l'utilisateur télécharger pdf (Page 300)

100

101

16-2 Time Guardian Series – Access Control Module

Using Access Control Module

Nexus 220 Integration

Wizard Setup for Nexus 220

The following paragraphs detail the steps involved in setting up the Nexus 220 Access Control

System during Employee Setup with the Setup Wizard (see Step 7: Employee Setup Wizard for

additional Wizard information).

Employees Setup for Nexus220

The Access Control Module must be activated for the Nexus 220 tab not to be grayed out. Once

this module is activated, Nexus 220 tab will be active during employees Step 7 Wizard Setup if

you selected to integrate the Nexus 220 for Access Control from the General tab of the Setup

Wizard. When Nexus 220 Access Control software is connected to an AC or EC controller 4

tags are available (see the following figure for an example with 4 Tags). Tag1 can be used to

assign access levels, sites, and tag options to the badge or tag number entered in the General

tab. Tag2, thru Tag4 can be used to add and configure additional tag(s) or badge(s) for the

employee to use. Click on the Nexus 220 tab and the following type of screen will appear:

For Nexus 220 Access Control use:

Enter PIN: The 5-digit number that an employee may have to enter at an access control device.

Click on Tag 1 through Tag 4 and the following type of screen will appear:

Note: For Tag 1 the Badge number (Tag Code) is disabled as it is Read only, but it is enabled

in the other tags. It will be Read only and the same as the Badge number.

1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 413 414

Commentaires sur ces manuels

Pas de commentaire

Amano Time Guardian Series Guide de l'utilisateur Page 300

Commentaires sur ces manuels

Produits connexes et manuels pour Claviers numériques Amano Time Guardian Series