Amano TCX-22 Manuel d'opérations télécharger pdf (Page 18)

16 Amano TCX-22 Operation Manual

Replacing the Ribbon

To Remove:

1. Remove the cover.

2. Pull the two white release tabs

upward and remove the ribbon

cassette.

To Insert:

1. If the print mechanism is down and a piece of paper cannot be

inserted, press the RESET button to move the carriage up. This will

make the ribbon installation easier.

2. Insert the ribbon cassette. Be sure to mount the ribbon between

the printer head and ribbon guide as arrows illustrate.

3. Turn the knob on the cassette clockwise one turn to take up any

slack in the ribbon.

4. Replace the cover and check the print quality to confirm that you

have installed the ribbon correctly.

Error Messages

Error Code Cause

E1 Pr

Home sensor, motor carriage stuck

E2 Pr

Time sensor, carriage stuck

E3 Pr

Home sensor

E4 Pr

Carriage stuck

General print error

Daylight Saving Time Program

For error messages E1 through E4, turn off the power before checking to

see that the carriage is not stuck or jammed. Also, check to see that the

ribbon cables are in good condition. After clearing any jams, restore the

power and press the RESET button. Contact your Amano Cincinnati

representative for assistance.

The dL

error message signifies that an attempt was made to get into the

Program mode during the Daylight Saving changeover one-hour lockout.

Wait one hour and you will be able to program the clock.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Pas de commentaire

Amano TCX-22 Manuel d'opérations Page 18